Skip to content

Desktop

The desktop enables using graphical applications on a Puhti or Mahti compute node.

In the Puhti web interface, the desktop can be launched as:

  • Mate or Xfce desktop, where one or several applications can be started. The applications mentioned below have been tested to work. Also other graphical tools available in Puhti could work.
  • Single application, currently are supported: CloudCompare, Grace, GRASS GIS, Maestro, MATLAB, QGIS, SAGA GIS, SNAP and VMD.

Only CPU rendering is supported in the graphical applications launched from the desktop. See here how to enable GPU-accelerated visualization for selected applications on Puhti.

In the Mahti web interface, only the Xfce desktop is available and no other options can be selected. The applications available in the desktop on Mahti are Maestro and VMD

Launching

  1. Open Desktop page under Apps
  2. Specify the needed resources. Desktop is run as batch job as anything else on the supercomputers, so the required resources need to be defined before launching the desktop. The recommended partiotion is interactive, so that the job could start as soon as possible, but if more resources are needed also other partitions are available.
  3. Puhti only: select Desktop Mate, Xfce or 'None'. Use 'None', if starting single application.

Connecting

There are two options for connecting to the remote desktop:

  1. With web-browser. The noVNC Connection tab can be used to connect to the remote desktop using a web browser by selecting wanted compression and quality and then clicking Launch Desktop. Using the browser to connect is recommended for most users.
  2. With VNC client. For better performance you can use a native VNC client, such as RealVNC or TigerVNC. Native VNC client may also be a good alternative if experiencing issues with clipboard integration between remote desktop and local host with the browser connection. Instructions for native VNC clients can be found in the Native instructions tab. This requires installing the VNC client on your local machine.

Using the desktop

The applications mentioned above have a direct shortcut on desktop.

For starting any other software available on the supercomputers:

  1. Open terminal
  2. Start the software as described in Applications section, usually module load XX and <start_command_for_XX>.

(The applications menu in desktop does not include Puhti or Mahti scientific applications, just basic Linux tools.)


Last update: June 13, 2023